Wood sustains little damage over time. Same may be the case with timber stairways. Frequent use of the stairs some other elements over time cause some damage to the timber stairs. The most frequent damages done to the timber stairs are: squeaking steps, damage treads or nosing, and cracked, damage or loose handrails and supporting.
1- The damage done to treads is mostly as a consequence of lack of lid. The most damage is carried out the nosing of the stair. You can merely remove the damaged timber and placed the new timber repair the problem. You would like to to do is actually by cut the 50mm wide section belonging to the damaged part. Use jigsaw to cut a new timber section of same size and screw it or glue it to the damaged section.
2- Squeaking steps can be for many reasons. Anyone could have to figure this out. Sometimes its caused due for the loose wedges or a defective joint between tread and bottom of the riser. Loose glue blocks can also be careful for squeaking tasks. Squeaking is sometimes common the actual world steps which are wide enough no proper central support. To find out the regarding squeaking step, must to inspect the underneath of the staircase.
- The first thing you need to do is to examine the glue blocks. Should be positioned properly between the tread and the riser. If you find any block missing or loose, replace it with new corner. Remember at least two blocks are required under each tread.
- The second step is to check all the wedges. Wedges become shriveled over time, so make sure all the wedges are well held at their respective positions. Any loose or worn wedge should be replaced with new piece.
- If is actually very not possible start viewing the bottom on the staircase, there is an additional way to fix the problem. What you need to attempt to do is to drive screw down the particular tread into the top of the the riser. Never forget to countersink the heads of screw properly.
- If observe the joint between tread and the riser has loosened up, you can easily drive screw from bottom side for the tread into the riser. You need three screws at equal distance to secure the ankle.
3- The 3rd thing which you to check could be the damaged or loose handrails and balusters. They are extremely dangerous for your timber stairs. You've to take quick remedial actions to stop severe damage.
- If you can apply small gaps and opening in handrails, just simply insert some glue into that gap or crack and use clamps to put both the parts together. But in case the cracks or openings are large, use dowel of equal length. If the damage is irreparable and wants replacement, have a new handrail of same length and join it with the existing handrail one help of screws, dowels or handrail bolts.
- The damaged balusters should need immediate treatment. Will be hard to get the decorative replacement for one's balusters, so best option is vehicle it in one way or another. The simple technique is to take the timber and join it with the present baluster with epoxy.